Pool Service in Phoenix and Nearby Towns
We look after backyard pools across Phoenix and the towns around it, from weekly cleaning to filter work, acid washes and equipment swaps. Below you will find where we go and what the desert does to pool water and surfaces, explained in plain English so you know what to watch for.
Towns on Our Routes
Our routes run through Phoenix and out to Glendale, Tempe, Scottsdale and Paradise Valley. On the west side we cover Tolleson, Litchfield Park, El Mirage and Youngtown, plus Sun City and Sun City West. Weekly pool cleaning follows the same routine in every one of them: a fixed service day, brushing the walls and tile, skimming the surface, and emptying the skimmer and pump baskets. We finish by checking chlorine, pH and alkalinity and adjusting them on the spot. You pay nothing extra for the chemicals we add, since they are part of the monthly price.
If you are unsure whether your street falls on a route, mention your address when you call. We will let you know if we can fit you into a weekly schedule or handle a one-time job such as green to clean recovery, a pool drain and refill, or calcium removal and tile cleaning. New weekly customers get their first month of service free. We work with no contract, so you can cancel anytime, with nothing to buy out and no notice period to sit through.
Towns we cover from Phoenix
- Phoenix
- Glendale
- Paradise Valley
- Sun City
- El Mirage
- Tolleson
- Youngtown
- Scottsdale
- Tempe
- Sun City West
- Litchfield Park
Not on the list? Call (602) 883-2314 and ask.
What the Desert Does to Your Pool
Hard water and calcium
Water from the tap in this part of Arizona is heavy with dissolved calcium. When the sun pulls water out of your pool, those minerals do not leave with it, so calcium hardness and total dissolved solids rise a little every month. You usually spot it first as a white or gray crust along the waterline tile. Ignore it and the same scale builds up inside heater exchangers and salt cells. That is why a periodic drain and refill and routine tile cleaning count as normal upkeep here, not extras.
Long, hot summers
Warm water and intense sun strip free chlorine out of a pool fast. Stabilizer, also called cyanuric acid, slows that loss, but every trichlor tablet adds more of it. Past a certain level, chlorine can no longer do its job, and a clear pool can turn green in a few days. We test for stabilizer and tell you when it is the actual cause.
Monsoon dust and debris
A single summer storm can leave dust, leaves and palm fronds in the water by evening. Fine dust gets past the skimmer and clogs the filter, so cartridge and DE filters need cleaning more often late in the season. We watch the pressure gauge, and a reading 8 to 10 psi over its clean level tells us it is time.
Older and newer pools side by side
Neighborhoods here went up over several decades, so original plaster pools sit near newer pebble finishes. Plaster etches and stains as it ages. An acid wash removes a thin layer to brighten it, which only makes sense if enough plaster is left, and we will tell you if it is not. Aging single-speed pumps are common too, and swapping one for a variable-speed pump is a frequent equipment installation job.
Drain rules, permits and HOAs
Each city sets its own rules for draining pool water, including where the discharge may go, so we confirm the local requirement before any drain and refill. Some equipment changes, such as new electrical work for a pump or heater, may need a permit, and many HOAs control where equipment can sit. We tell you which apply before work begins.
Find Out If Your Pool Is on Our Routes
Give us your town and describe what you are seeing in the water or on the tile. We will walk you through the likely cause in plain terms and give you a free quote during the same call.